- Edmonton Stock: 3
60 Watt 12V DC Dimmable Magnetic Driver ML60S12DC
60W magnetic constant-voltage LED driver with 12V DC output for dimmable LED strip and low-voltage lighting systems. Commonly used where a 120V AC feed needs a 12V DC Class 2-style driver with phase dimming; actual dimmer compatibility and performance depend on load, wiring layout, and installation conditions.
What this product is for
This magnetic LED driver converts 120V AC input to 12V DC output for compatible low-voltage LED lighting loads up to 60W. It is intended for dimmable constant-voltage applications such as LED ribbon, strip lighting, and other 12V DC fixtures that require a magnetic driver.
Use for
- 12V DC LED strip and ribbon lighting
- Dimmable under-cabinet, cove, accent, and display lighting
- Residential and light commercial low-voltage LED systems
- Installations using a compatible low-voltage magnetic dimmer
Avoid for
- 24V DC lighting loads
- Constant-current LED fixtures
- Loads above 60W or above 5A output
- Applications where dimmer compatibility has not been confirmed
Best for
Best for electricians and lighting installers who need a 12V DC magnetic driver for phase-dimmed LED loads in homes, millwork, and light commercial spaces. A practical rule of thumb for LED strip sizing is to keep connected load below the driver maximum and allow headroom where possible for stable operation and future serviceability.
Installed in
Typically installed in indoor low-voltage lighting systems fed from a 120V, 60 Hz branch circuit. The referenced specification sheet for this SKU family also lists a black powder-coated steel enclosure with dimensions of approximately 8.13 x 3.93 x 1.59 in (206 x 100 x 40 mm), which can help when planning mounting space.
Why this product exists
LED strip and ribbon systems require the correct constant-voltage DC power supply to operate properly. This driver exists to provide 12V DC output with dimming capability from a standard 120V AC supply, helping match dimmable low-voltage LED loads to common wall-control installations.
Compared with similar products
Compared with electronic LED drivers, a magnetic driver is commonly selected where magnetic low-voltage dimming compatibility is preferred. Compared with higher-wattage models, this 60W unit suits shorter runs and smaller lighting zones. Typical LED strip guidance: 1.5 W/ft is often used for accent lighting, 3 W/ft for task lighting, and 5+ W/ft for primary light levels. Actual loading depends on the connected product, run length, voltage drop, and local code.
Actual performance depends on installation conditions, dimmer selection, wiring layout, connected load, and local electrical code.
Specifications
- Manufacturer part number: ML60S12DC
- Brand: Axite Lighting Canada
- Product type: Magnetic dimmable LED driver
- Input voltage: 120V AC, 60 Hz
- Output voltage: 12V DC
- Maximum output power: 60W
- Maximum output current: 5A
- Dimming: Magnetic low-voltage dimmer compatible
- Warranty: 5 years
- Approximate product weight listed by Axite page: 3.85 lb (1.75 kg)
- Referenced spec-sheet enclosure dimensions: 8.13 x 3.93 x 1.59 in (206 x 100 x 40 mm)
- Watts60W
- FinishBlack
- Mounting TypePost or Wall Mount
- Volts12V DC
- TypeMagnetic
- LocationOutdoor
- Height8.13"
- Width3.93"
- Depth1.59"
- BrandAxite Lighting Canada
- Warranty5 year
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.
Related products
- Edmonton Stock: 8
- Edmonton Stock: 7
3 w/ft Outdoor Accent LED Strip - 238 lm/ft · 2700K · 12V · 16 ft
EV3-OUT-16-12V-2700
112 – Loyalty Rewards- Edmonton Stock: 14
- Edmonton Stock: 67
- Edmonton Stock: 477
Magnetic LED Driver · 20W 12V DC · Dimmable Class 2 · Axite Lighting Inc ML20S12DC
ML20S12DC
Restocking122 – Loyalty Rewards- Edmonton Stock: 1
