Electric Infrared Patio Heater · 6000W 208V · Dual Element White 61-1/4 in (1556 mm) · Infratech WD-6028-SS-WH
What this product is for
This electric infrared patio heater is used to provide directional outdoor comfort heat on patios, covered decks, restaurant seating areas, and other open-air spaces. It is a dual-element Infratech WD-Series unit in a white finish, rated 6000W at 208V.
Use for
Use for larger outdoor areas where a stronger heat concentration is needed, especially when the heater is mounted higher than typical low-clearance installations. It is commonly selected for wall, ceiling, floor, or pole mounting, and can be paired with compatible controls or a duplex stack switch for half-power or full-power operation.
Avoid for
Avoid using this heater where a lower-voltage branch circuit, lower load, or compact heater length is required. It is also not the right choice where corrosion conditions call for marine-grade 316 stainless steel rather than the standard 304 stainless steel construction.
Best for
Best for contractors and specifiers needing a 208V dual-element infrared heater for larger-scale outdoor comfort heating with a clean white appearance. This model suits installations where mounting height is typically about 8 to 14 ft (2.4 to 4.3 m) and more concentrated directional heat is preferred.
Installed in
Typically installed in covered patios, outdoor dining areas, terraces, pergolas, hospitality spaces, and residential outdoor living areas. Overall heater size is approximately 61-1/4 in W x 8-3/16 in H x 9-3/8 in D (1556 x 208 x 238 mm).
Why this product exists
The WD-Series is designed for applications that need more concentrated heat output than lighter-duty outdoor heaters. Dual elements help support staged or controlled operation, which can be useful where conditions change through the day or season.
As a rule of thumb, 208V systems deliver less output than an equivalent 240V heater circuit. Actual performance depends on installation conditions, wind exposure, mounting height, insulation, layout, and local electrical code.
Compared with similar products
Compared with single-element patio heaters, this dual-element model is better suited to larger spaces and higher mounting heights. Compared with marine-grade Infratech models, this version uses 304 stainless steel rather than 316 stainless steel, making it a better fit for standard exterior environments rather than severe coastal exposure.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6028-SS-WH
- Series: WD-Series
- Product type: Electric infrared patio heater
- Element configuration: Dual element
- Wattage: 6000W
- Voltage: 208V
- Current: 28.8A
- Finish: White
- Construction: 304 stainless steel body
- Nominal length: 61-1/4 in (1556 mm)
- Overall dimensions: 61-1/4 in W x 8-3/16 in H x 9-3/8 in D (1556 x 208 x 238 mm)
- Typical mounting height guidance: 8 to 14 ft (2.4 to 4.3 m)
- Mounting options: Wall, ceiling, floor, or pole
- Control compatibility: Can be used with compatible Infratech controls or duplex stack switching for staged output
- Application: Outdoor residential and commercial comfort heating
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.