Infrared Patio Heater · 6000W 208V · Dual Element Stainless Steel · Infratech WD-6028-SS
What this product is for
This electric infrared patio heater is used to provide directional radiant heat for outdoor and semi-protected areas such as patios, restaurant seating, terraces and covered commercial spaces. The WD-6028-SS is a dual-element Infratech heater rated 6000W at 208V with a stainless steel finish.
Use for
Use for outdoor living areas, hospitality patios, amenity spaces, covered decks and other locations where fast radiant comfort heat is preferred over forced air. It is commonly selected where electricians or designers need a long heater body at approximately 61-1/4 in (about 1556 mm) with even heat distribution from a dual-element layout.
Avoid for
Avoid using this heater where supply voltage does not match 208V, where local clearance requirements cannot be met, or where a different enclosure or corrosion package is required for severe coastal exposure. It is not a general indoor space heater for enclosed occupied rooms unless the installation is specifically designed and approved for that application.
Best for
Best for larger outdoor seating or gathering areas that need concentrated radiant heat from a fixed electric heater. This model suits projects where stainless steel appearance matters and where dual-element performance is preferred for broader heat coverage.
Installed in
Typically installed in covered patios, restaurant canopies, pergolas, soffits and exterior commercial gathering areas. Manufacturer literature indicates wall or ceiling mounting with supplied brackets, subject to the installation manual and local code.
Why this product exists
This heater exists for projects that need higher-output radiant heat without combustion appliances or fuel piping. Compared with lower wattage units, 6000W models are commonly used where mounting heights and open-air heat loss call for more concentrated output. As a rule of thumb, 208V systems deliver the heater's listed 6000W rating on this model, and branch-circuit sizing should be confirmed from the nameplate, installation instructions and applicable Canadian Electrical Code requirements.
Compared with similar products
Compared with single-element heaters, this dual-element model is intended for larger-scale coverage and more even heat spread. Compared with marine-grade versions, this stainless steel model uses standard corrosion-resistant stainless construction rather than the upgraded 316 marine-grade option intended for harsher coastal environments.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6028-SS
- Product family: WD-Series
- Product type: Electric infrared patio heater
- Element design: Dual element
- Power rating: 6000W
- Voltage: 208V
- Current draw: 28.8A
- Finish: Stainless steel
- Length: 61-1/4 in (about 1556 mm)
- Approximate dimensions: 61.25 x 8 x 3 in (about 1556 x 203 x 76 mm)
- Mounting: Wall or ceiling mount with brackets, per manufacturer instructions
- Application: Outdoor and patio radiant comfort heating
Estimated coverage and installation suitability vary with mounting height, wind exposure, ambient conditions and site layout. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.