Dual Element Infrared Patio Heater · 6000W 208V 61-1/4 in (1556 mm) · Bronze Body with Stainless Steel Trim · Infratech WD-6028-SS-BR
What this product is for
This Infratech WD-Series dual element electric infrared patio heater is built to provide directional radiant heat for larger outdoor and semi-enclosed areas. The WD-6028-SS-BR is a 6000W, 208V model with a bronze body, stainless steel trim, and an overall length of 61-1/4 in (1556 mm).
Use for
Use for covered patios, restaurant seating areas, hospitality spaces, outdoor amenity areas, garages, workshops, and other locations where electric infrared heat is preferred over fuel-fired heating. It suits projects that need a long heater body with dual elements for broader heat distribution.
Avoid for
Avoid using this heater where the available supply voltage does not match 208V, where local clearances cannot be maintained, or where an enclosed indoor comfort-heating appliance is required instead of directional radiant heat. Do not treat estimated coverage as a guaranteed heated area in exposed or windy installations.
Best for
Best for electricians and contractors specifying hardwired outdoor electric heat in commercial patios or higher-end residential projects. A practical rule of thumb is that infrared comfort coverage is highly installation-dependent, so heater spacing, mounting height, and exposure to wind matter as much as wattage. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Installed in
Typically installed in covered outdoor living areas, restaurant patios, pergolas, canopies, and similar overhead mounting locations. This model is commonly selected where a longer 61-1/4 in (1556 mm) heater fits the layout and a bronze finish is preferred.
Why this product exists
This product exists for projects that need electric radiant heat without combustion gases, propane cylinders, or visible flame. The dual element WD-Series format provides high wattage output in a single linear heater for larger zones and coordinated architectural installations.
Compared with similar products
Compared with lower-wattage patio heaters, this 6000W unit is intended for larger heating zones and typically requires branch-circuit planning consistent with its 28.8A load at 208V. As a trade-level guide, fixed electric heating loads are commonly sized with continuous-load considerations in mind, so installers often review breaker, conductor, controls, and local code requirements before final selection.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6028-SS-BR
- Series: WD-Series
- Product type: Dual element electric infrared patio heater
- Rated power: 6000W
- Voltage: 208V
- Current draw: 28.8A
- Length: 61-1/4 in (1556 mm)
- Dimensions: 61.25 x 8 x 3 in (approximately 1556 x 203 x 76 mm)
- Finish: Bronze body with stainless steel trim
- Application: Outdoor and indoor/outdoor covered areas, subject to manufacturer instructions and code-compliant installation
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.