Infrared Patio Heater · 6000W 208V · Dual Element Black Body · Infratech WD-6028-SS-BL
What this product is for
The Infratech WD-6028-SS-BL is a dual-element electric infrared patio heater designed to deliver 6000W of radiant heat at 208V for larger indoor or outdoor covered areas. It is built for installations where fast, directional heat is preferred over forced air heating.
Use for
Use for restaurant patios, commercial terraces, outdoor dining areas, covered decks, vestibules, and residential outdoor living spaces where a hardwired radiant heater is required. This heater is also suitable where silent operation and zero on-site emissions are preferred.
Avoid for
Avoid using this heater where supply voltage does not match 208V, where mounting height falls outside the manufacturer’s recommended range, or in locations needing broad ambient space heating rather than directional radiant heat. Do not select it as a plug-in heater or for low-clearance installations without confirming the manufacturer’s installation requirements.
Best for
Best for larger seating and gathering zones that need concentrated overhead heat. The dual-element WD-Series format is commonly chosen when contractors want stronger heat concentration than smaller single-element models and when staged or custom control options may be required.
Installed in
Typically installed on walls, ceilings, or flush-mount assemblies in covered outdoor or indoor commercial and residential spaces. The heater body is approximately 61.25 in. long (about 1556 mm), 8 in. wide (about 203 mm), and 3 in. high (about 76 mm), so allow practical clearance for mounting and service access.
Why this product exists
This model exists for projects that need higher-output radiant heat from a slim linear heater body without combustion, open flame, or fan noise. Infratech’s WD-Series uses a dual-element design to provide concentrated heat for larger coverage needs and supports indoor/outdoor use with compatible control options.
Compared with similar products
Compared with lower-wattage infrared heaters, this 6000W model is better suited to larger zones and higher mounting applications. Compared with gas patio heaters, electric infrared units like this one provide silent operation and no on-site combustion. As a rule of thumb for radiant patio heating, comfort results are highly dependent on mounting height, exposure, and wind conditions, so layout should be reviewed before ordering.
At 208V, a 6000W load draws approximately 28.8A, so branch circuit sizing, overcurrent protection, and controls should be confirmed by a licensed electrician and local code. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6028-SS-BL
- Series: WD-Series
- Product type: Electric infrared patio heater
- Element design: Dual element
- Power: 6000W
- Voltage: 208V
- Current draw: 28.8A
- Finish/colour: Black body
- Construction: 304 stainless steel body with colour finish
- Application: Indoor/outdoor use
- Approximate dimensions: 61.25 in. x 8 in. x 3 in. (1556 x 203 x 76 mm)
- Approximate weight: 20 lb (9.1 kg)
- Typical mounting height: 7 ft to 12 ft (2.1 m to 3.7 m)
- Listings: UL/cUL listed
- Controls: Compatible with Infratech duplex stack switch and custom control options
- Warranty: 3-year manufacturer warranty
- Country of manufacture: USA
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.