Dual Element Infrared Patio Heater · 6000W 208V · Beige 61-1/4 in (1556 mm) · Infratech WD-6028-SS-BE
What this product is for
The Infratech WD-6028-SS-BE is a dual-element electric infrared heater for outdoor and indoor/outdoor comfort heating. It is designed for spaces that need concentrated radiant heat from a higher mounting position, including patios, hospitality seating areas, covered terraces, and commercial outdoor zones.
Use for
Use for wall, ceiling, or recessed-style patio heating layouts where a 208V, 6000W heater is specified. This model is commonly selected when installers need a long-body heater with dual elements, cUL/UL listed indoor/outdoor use, and compatibility with Infratech duplex stack switch or custom control options.
Avoid for
Avoid for low-clearance installations, enclosed spaces without proper design review, or projects where the available supply voltage does not match 208V. It is also not the right choice where a lower-wattage heater would better suit a small seating area or limited circuit capacity.
Best for
Best for larger patios and commercial outdoor seating areas where more directional heat is preferred. Dual-element WD-Series heaters are typically used in spaces with approximately 8 to 14 ft (2.4 to 4.3 m) mounting heights, helping maintain comfort where single-element models may not provide the same concentration of heat.
Installed in
Typically installed in covered residential patios, restaurant patios, hospitality venues, pergolas, indoor/outdoor amenity spaces, and similar locations. A licensed electrician should confirm branch circuit sizing, controls, mounting clearances, and suitability for the site.
Why this product exists
This heater exists for projects that need electric radiant heat without open flame, with a finish option that blends into architectural surroundings. The dual-element WD platform is intended for larger-scale coverage needs and for installations where stronger directional output is useful.
Compared with similar products
Compared with lower-wattage or single-element patio heaters, this 6000W WD-Series model is intended for heavier-duty applications and higher mounting heights. Compared with 240V versions, the 208V model must match the building power available. As a rule of thumb for electric heating loads, controls and branch circuits must be selected to suit the connected load and continuous-duty requirements. Actual performance depends on installation conditions, wind exposure, mounting height, and local electrical code.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6028-SS-BE
- Series: WD-Series
- Product type: Dual-element infrared electric patio heater
- Rated power: 6000W
- Voltage: 208V
- Current: 28.8A
- Length: 61.25 in (1556 mm)
- Dimensions: 61.25 x 8 x 3 in (1556 x 203 x 76 mm)
- Finish: Beige
- Construction: 304 stainless steel housing with colour finish
- Mounting: Indoor/outdoor wall, ceiling, or compatible recessed applications per manufacturer instructions
- Typical mounting height: 8 to 14 ft (2.4 to 4.3 m)
- Controls: Compatible with Infratech duplex stack switch and custom control options
- Listing: UL/cUL listed for indoor/outdoor use
- Warranty: 3-year factory warranty
- Country of manufacture: USA
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.