Infrared Patio Heater · 6000W 240V · Dual Element Stainless Steel · Infratech WD-6024-SS
What this product is for
This electric infrared patio heater is used to provide radiant comfort heat in covered or open outdoor areas where gas piping is not preferred. The WD-6024-SS is a 6000W, 240V dual-element unit in stainless steel, built for larger residential patios and light commercial hospitality spaces.
Use for
Use for patios, pergolas, terraces, restaurant seating areas, club spaces, and other outdoor gathering areas where directional radiant heat is needed. It is commonly selected when electricians or contractors need a hardwired 240V heater with a longer 61-1/4 in (about 1556 mm) body for wider heat spread.
Avoid for
Avoid for small enclosed indoor rooms, low-clearance installations, or applications where mounting clearances and electrical load cannot be met. Do not use it as a whole-home or primary space-heating substitute.
Best for
Best for larger outdoor zones that need stronger radiant output than smaller single-element heaters. The dual-element layout helps distribute heat more evenly across seating and standing areas.
Installed in
Typically installed on wall or ceiling structures in covered patios, outdoor kitchens, commercial entrances, and hospitality venues. A stainless steel mounting kit is commonly included. Electricians should size branch circuits and controls for a 6000W, 240V load, which is approximately 25A running current.
Why this product exists
This model exists for projects that need clean electric radiant heat without open flame, propane storage, or combustion by-products. It suits sites where appearance, directional heat, and low day-to-day maintenance matter.
Compared with similar products
Compared with lower-wattage patio heaters, this 6000W model is intended for larger coverage areas and higher mounting applications. Typical manufacturer guidance indicates about 8 x 10 ft (2.4 x 3.0 m) comfort heat coverage. As a rule of thumb, larger outdoor areas or wind-exposed spaces may require multiple heaters for even comfort. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6024-SS
- Product family: WD Series
- Product type: Electric infrared patio heater
- Element design: Dual element
- Wattage: 6000W
- Voltage: 240V
- Current: 25A
- Finish/material: Brushed 304 stainless steel
- Length: 61-1/4 in (about 1556 mm)
- Approximate dimensions: 61.25 x 8 x 3 in (about 1556 x 203 x 76 mm)
- Typical comfort heat coverage: 8 x 10 ft (2.4 x 3.0 m)
- Mounting: Wall or ceiling mount; stainless steel mounting kit commonly included
- Application: Outdoor residential and light commercial heating
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.