Infrared Patio Heater · 6000W 240V 61-1/4 in (1556 mm) Dual Element Bronze Stainless Steel · Infratech WD-6024-SS-BR
What this product is for
This electric infrared radiant heater is for patios, covered decks, restaurant seating areas, vestibules, garages, workshops, and other spaces where direct radiant heat is preferred over forced air. The Infratech WD-Series dual-element design is intended for larger coverage areas and concentrated heat output.
Use for
Use for wall or ceiling mounting in residential or commercial installations requiring 6000W at 240V. It is suited to covered outdoor living spaces, hospitality seating, and indoor commercial areas where wind-resistant radiant comfort heat is needed.
- Large patio and deck heating
- Restaurant and hospitality outdoor seating
- Garages, workshops, and semi-exposed commercial spaces
- Projects needing a long 61-1/4 in (1556 mm) dual-element heater body
Avoid for
Avoid for small enclosed rooms that do not need high-wattage radiant heat, or installations where the required clearances, mounting height, branch circuit capacity, or control method cannot be met. Do not select this heater based only on wattage without confirming site exposure, ceiling height, and control requirements.
Best for
Best for electricians and contractors specifying a higher-output infrared heater for larger seating or gathering zones. This model is typically selected when a single-element heater will not provide enough concentrated heat coverage.
Installed in
Typically installed in covered patios, pergolas, restaurant canopies, retail entrances, garages, and indoor commercial spaces. The WD-6024 format is commonly referenced for approximately 11 x 11 ft coverage when mounted around 10 to 14 ft high, but this is typical guidance only. Actual performance depends on mounting height, ambient temperature, wind, surrounding surfaces, insulation, layout, and local electrical code.
Why this product exists
This heater exists for projects that need direct radiant warmth without moving air. Compared with lower-wattage units, a 6000W dual-element heater helps cover larger open areas and can reduce the number of fixtures required in some layouts.
Trade guidance: at 6000W on 240V, the heater draws approximately 25A, so branch circuit sizing, overcurrent protection, disconnecting means, and controls must be selected to suit the installation and applicable code.
Compared with similar products
Compared with single-element patio heaters, this WD-Series dual-element model is designed for larger-scale coverage and more concentrated radiant output. Compared with gas patio heaters, electric infrared heat avoids open flame and directs heat to people and surfaces rather than heating large volumes of air.
The bronze stainless steel finish is intended for projects where appearance matters as much as output, while the long low-profile body suits architectural wall and ceiling layouts.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-6024-SS-BR
- Series: WD-Series
- Product type: Dual-element electric infrared radiant heater
- Rated power: 6000W
- Voltage: 240V
- Current: 25A
- Length: 61-1/4 in (1556 mm)
- Approximate dimensions: 61.25 x 8 x 3 in (1556 x 203 x 76 mm)
- Mounting: Wall or ceiling mount with supplied swivel brackets; optional flush mount frame available on WD-Series
- Application: Indoor or outdoor covered-area heating
- Finish: Bronze stainless steel
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
Standard Shipping-Free on orders over $500 in Metropolitan Areas / Subject to $750 in Rural Areas.
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998(Updated August 2026)
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.