Electric Infrared Patio Heater · 4000W 208V 39 in · Dual Element White · Infratech WD-4028-SS-WH
What this product is for
This electric infrared patio heater is for warming outdoor or semi-sheltered areas such as patios, restaurant seating, terraces, covered decks, and similar spaces where direct radiant heat is preferred over forced air. The WD-Series dual-element design is intended for larger coverage areas and more concentrated heat than smaller single-element models.
Use for
Use for 208V outdoor heating projects where a 4000W heater matches the available electrical service and the application benefits from a 39 in (991 mm) dual-element fixture. Commonly used in hospitality, multi-residential amenity areas, and higher-end residential patios. Typical guidance: dual-element Infratech heaters are often installed with compatible custom controls or duplex/stack switches to allow half-power or full-power operation, depending on conditions.
Avoid for
Avoid for locations that only have 240V service unless the heater model is specifically matched to that voltage. Avoid using this as a whole-space indoor heating substitute or where mounting clearances, weather exposure, or control requirements have not been reviewed. Actual performance depends on installation conditions, mounting height, wind, ambient temperature, and local electrical code.
Best for
Best for contractors and specifiers needing a white-finish infrared heater for visible surface-mounted outdoor applications, especially where a shorter 39 in body is preferred over longer heater formats. It suits projects that need concentrated radiant heat with a cleaner architectural appearance.
Installed in
Typically installed in covered patios, pergolas, restaurant canopies, outdoor lounges, clubhouses, and commercial entrances. Manufacturer guidance for the WD-Series indicates mounting heights up to 12 ft (3.7 m), subject to the installation manual and site conditions.
Why this product exists
This model exists for projects that need more intense radiant output from a compact dual-element heater on 208V power. Compared with lower-wattage or single-element units, it is aimed at larger-scale outdoor comfort heating while keeping the fixture length at 39 in (991 mm).
Compared with similar products
Compared with Infratech W-Series single-element heaters, the WD-Series is built for more concentrated heat and higher mounting capability. Compared with 240V versions of the same 4000W platform, this 208V model is intended specifically for 208V electrical systems and draws approximately 19A at rated voltage. White-body versions are created by adding the white suffix to the base WD-4028 stainless model designation.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-4028-SS-WH
- Series: WD-Series
- Product type: Electric infrared patio heater
- Element configuration: Dual element
- Rated power: 4000W
- Voltage: 208V
- Current: 19A
- Length: 39 in (991 mm)
- Approximate dimensions from distributor listing: 39 x 8 x 3 in (991 x 203 x 76 mm)
- Finish: White body
- Construction: 304 stainless steel base construction
- Mounting guidance: Up to 12 ft (3.7 m), subject to manufacturer instructions
- Control note: Commonly paired with compatible custom controls; duplex/stack switching may allow half/full power operation
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.