Dual-Element Infrared Patio Heater · 4000W 240V · 39 in (991 mm) Stainless Steel with Beige Finish · Infratech WD-4024-SS-BE
What this product is for
This fixed electric infrared heater is designed for larger residential and light commercial spaces that need concentrated radiant heat without fuel storage or open flame. The WD-Series dual-element format is intended for applications where broader heat output is needed than a single-element heater can typically provide.
Use for
Use for covered patios, outdoor dining areas, terraces, screened rooms, garages, workshops, and similar indoor/outdoor spaces where a 240V hardwired heater is appropriate. It is commonly selected for wall, ceiling, pole, or flush-mount installations where the heater length, wattage, and mounting height suit the layout.
Avoid for
Avoid using this heater where branch circuit capacity, control gear, or mounting clearances do not match the heater requirements. It is also not the right choice where exact area coverage must be guaranteed, since radiant comfort is affected by wind, ceiling height, insulation, and occupant position.
Best for
Best for electricians and contractors specifying a 240V infrared heater for larger seating or gathering zones that need more concentrated output from a compact 39 in (991 mm) body. The beige body designation is suited to projects where a softer architectural finish is preferred over a standard stainless appearance.
Installed in
Typically installed in residential patios, condo balconies where permitted, restaurant patios, hospitality spaces, and covered commercial outdoor areas. Manufacturer literature indicates WD-Series dual-element heaters are commonly mounted in locations with mounting heights up to approximately 12 ft (3.7 m), subject to model application and clearance requirements.
Why this product exists
This model exists for projects that need stronger radiant output and larger-scale coverage than smaller single-element heaters. Dual elements help deliver more concentrated heat for larger zones while keeping the heater body relatively compact.
Typical trade guidance: a 4000W 240V fixed heater draws about 16.7A, so branch circuit sizing, controls, and continuous-load treatment should be reviewed during design and installation. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Compared with similar products
Compared with lower-wattage single-element infrared heaters, this WD-Series unit is generally chosen for larger coverage needs and higher mounting applications. Compared with fuel-fired patio heaters, it offers electric infrared operation with no on-site combustion and no propane cylinder handling. Compared with shorter electric heaters, the 39 in (991 mm) body gives more output while still fitting many patio and soffit layouts.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-4024-SS-BE
- Series: WD-Series
- Heater type: Electric infrared radiant heater
- Element configuration: Dual element
- Rated power: 4000W
- Voltage: 240V
- Current: 16.7A
- Heater length: 39 in (991 mm)
- Body/finish: Stainless steel body with beige finish designation
- Application: Indoor/outdoor
- Mounting options: Wall, ceiling, pole, or optional flush mount frame in suitable applications
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.