Infrared Dual Element Patio Heater · 3000W 208V · 33 in (838 mm) Biscuit Stainless Steel · Infratech WD-3028-SS-BI
What this product is for
This electric infrared radiant heater is used to add directional comfort heat to patios, terraces, hospitality seating areas, covered outdoor spaces and similar indoor/outdoor applications. It is an Infratech WD-Series dual-element unit with a 3000W output at 208V in a 33 in (838 mm) housing.
Use for
Use for covered patios, restaurant seating, vestibules, garages, workshops and other spaces where electric radiant heat is preferred over fuel-fired heating. It is commonly selected when the installation height is higher than low-profile single-element heaters and when more concentrated heat is needed.
Avoid for
Avoid using this heater where supply voltage does not match 208V, where clearances and mounting requirements cannot be maintained, or in fully exposed locations where wind will significantly reduce perceived heat. Do not use it as a substitute for whole-room space heating calculations.
Best for
Best for electricians and contractors specifying electric radiant heat for premium outdoor areas, recessed-style layouts and projects that need a compact 33 in (838 mm) heater with dual elements. The biscuit finish suits architectural installations where a neutral body colour is preferred.
Installed in
Typically installed on patios, pergolas, soffits, covered decks, commercial outdoor dining areas and similar structures. Manufacturer literature indicates WD-Series dual-element heaters are commonly used in applications with mounting heights up to approximately 12 ft (3.7 m), subject to layout and clearance requirements.
Why this product exists
This model exists for projects that need more concentrated radiant output than lighter-duty single-element heaters. Dual-element WD-Series heaters are commonly paired with Infratech control options for staged or variable comfort control, including half-power/full-power style operation depending on the control scheme used.
Compared with similar products
Compared with single-element patio heaters, this dual-element WD-Series model is intended for more concentrated heat and higher mounting applications. Compared with 240V versions, this 208V model is matched to 208V electrical systems and should not be substituted without confirming circuit voltage, amperage and controls. As a rule of thumb for continuous loads, electricians typically size branch circuits at 125% of heater load and verify local code, disconnecting means and control compatibility.
Actual performance depends on installation conditions, mounting height, wind, enclosure, insulation and local electrical code.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-3028-SS-BI
- Series: WD-Series
- Product type: Electric infrared radiant heater
- Element configuration: Dual element
- Power: 3000W
- Voltage: 208V
- Current: 14A
- Length: 33 in (838 mm)
- Housing material: 304 stainless steel
- Finish: Biscuit
- Application: Indoor/outdoor radiant comfort heating
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
Standard Shipping-Free on orders over $500 in Metropolitan Areas / Subject to $750 in Rural Areas.
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998(Updated August 2026)
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.