Electric Infrared Patio Heater · 3000W 240V · Dual Element Biscuit Finish · Infratech WD-3024-SS-BI
What this product is for
The Infratech WD-3024-SS-BI is a 3000W, 240V electric infrared patio heater designed for outdoor comfort heating in residential and light commercial spaces. It uses a dual-element configuration in a 33 in (838 mm) body to deliver concentrated radiant heat to seating and gathering areas.
Use for
Use this heater for covered patios, pergolas, verandas, restaurant patios, hospitality spaces, and outdoor waiting or dining areas where silent, directional heat is needed. It is commonly selected when electricians or contractors need a hardwired 240V infrared heater with a finished appearance for architectural outdoor installations.
Avoid for
Avoid using this heater as whole-space indoor heating or where broad ambient air heating is expected. It is better suited to spot and zone heating than to heating enclosed rooms uniformly.
Best for
Best for projects that need a compact dual-element heater with a designer biscuit finish and 240V supply. This size is often chosen where wall or ceiling space is limited but stronger radiant output is still required.
Installed in
Typically installed in covered outdoor residential and commercial applications, including patios, decks, outdoor kitchens, restaurant seating areas, and similar sheltered spaces. Installation method, clearances, controls, and mounting location should follow the manufacturer instructions and applicable Canadian electrical code.
Why this product exists
This product exists to provide targeted outdoor heat without moving air, making it useful in spaces where gas heaters are impractical or where a clean electric infrared solution is preferred. Compared with lower-wattage units, 3000W offers more concentrated output for small to mid-sized seating zones.
As a rule of thumb, electric comfort heating is selected by zone rather than floor area alone. Actual comfort coverage is approximate and depends on mounting height, wind exposure, ambient temperature, enclosure, and layout.
Compared with similar products
Compared with single-element patio heaters, this WD-Series dual-element model is intended for more concentrated heat delivery and larger-scale coverage needs within the Infratech lineup. At 240V and 12.5A, it can fit applications where a moderate-load dedicated heating circuit is available.
Typical continuous-load planning still applies at 80% breaker loading. Actual branch-circuit design, controls, and grouping depend on the full connected load and local code requirements.
Specifications
- Brand: Infratech
- Manufacturer part number: WD-3024-SS-BI
- Series: WD-Series
- Product type: Electric infrared patio heater
- Heater style: Dual element
- Rated power: 3000W
- Voltage: 240V
- Current: 12.5A
- Length: 33 in (838 mm)
- Approximate dimensions: 33 x 8 x 3 in (838 x 203 x 76 mm)
- Finish/colour: Biscuit
- Application: Outdoor comfort heating
Actual performance depends on installation conditions, mounting height, wind, insulation, layout, and local electrical code.
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
Standard Shipping-Free on orders over $500 in Metropolitan Areas / Subject to $750 in Rural Areas.
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998(Updated August 2026)
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.