Single Element Infrared Patio Heater · 4000W 208V · Almond Finish · Infratech W-4028-SS-AL
What this product is for
This single-element electric infrared heater is used to warm patios, terraces, covered outdoor seating areas, and similar residential or light commercial spaces where direct radiant heat is preferred over forced air.
Use for
Use for wall, ceiling, or flush-mount patio heating applications where 208V power is available and a long 61 1/4 in (about 1556 mm) heater body suits the layout. It is commonly selected for restaurants, hospitality spaces, condo balconies, and covered backyard patios.
Avoid for
Avoid using this heater where supply voltage does not match 208V, where mounting clearances cannot be maintained, or where broad-area heating is expected in fully open and windy locations without proper heater layout.
Best for
Best for electricians and contractors specifying a surface-mounted or recessed-capable infrared heater with a single-element format, colour-matched almond finish, and compatibility with Infratech control options.
Installed in
Typically installed in covered patios, pergolas, restaurant patios, outdoor lounges, and other sheltered gathering areas. Typical mounting height for this wattage and series is approximately 8 to 12 ft (2.4 to 3.7 m), depending on the application and comfort target.
Why this product exists
This heater provides targeted radiant comfort heat without moving air, making it useful where gas piping is not desired or where a clean electric heating layout is preferred. The W-Series is intended for straightforward installations that need concentrated directional heat from a single element.
Compared with similar products
Compared with dual-element patio heaters, this single-element model is a simpler choice for many standard installations and uses a longer body length to deliver 4000W output at 208V. As a rule of thumb, 208V systems deliver less output than the same heater family at 240V, so layout and heater count should be reviewed during design. Actual comfort and coverage depend on mounting height, wind exposure, ambient temperature, and local installation conditions.
Specifications
- Manufacturer: Infratech
- Manufacturer part number: W-4028-SS-AL
- Series: W-Series
- Heater type: Single-element electric infrared patio heater
- Power rating: 4000W
- Voltage: 208V
- Current: 19A
- Finish: Almond
- Construction: 304 stainless steel body with colour finish
- Nominal length: 61 1/4 in (about 1556 mm)
- Approximate dimensions: 61 1/4 in W x 8 3/16 in H x 9 3/8 in D (1556 x 208 x 238 mm)
- Typical mounting height: 8 to 12 ft (2.4 to 3.7 m)
- Mounting options: Surface mount with recessed mounting options available
- Application: Outdoor and semi-outdoor radiant heating
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
Standard Shipping-Free on orders over $500 in Metropolitan Areas / Subject to $750 in Rural Areas.
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998(Updated August 2026)
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.