Single Element Infrared Patio Heater · 4000W 240V · White 61-1/4 in (1556 mm) · Infratech W-4024-SS-WH
What this product is for
This electric infrared patio heater is designed for outdoor and semi-outdoor comfort heating in residential and commercial settings. It is a single element Infratech W-Series unit with a white body finish, 4000W output, 240V rating, and a 61-1/4 in (1556 mm) length.
Use for
Use it for patios, covered decks, restaurant seating areas, pergolas, entrance canopies, and similar spaces where directional radiant heat is preferred. It suits projects that need a long single-element heater with a clean white finish and standard 240V power.
Avoid for
Avoid using this heater where a shorter body length is required, where supply voltage does not match 240V, or where the installation height falls outside the manufacturer guidance. It is also not the right choice when broad multi-zone coverage would be better served by multiple heaters or a dual-element model.
Best for
Best for contractors and specifiers selecting radiant heat for patios and outdoor commercial seating where appearance, directional comfort, and electric operation matter. The white finish can blend into light-coloured ceilings and structures more cleanly than stainless-only visible finishes.
Installed in
Commonly installed in covered outdoor living areas, hospitality patios, retail exterior waiting areas, and other sheltered spaces. Manufacturer guidance for W-Series single element heaters indicates mounting heights between 6 and 10 ft (1.8 and 3.0 m), while the W-40 heat coverage planning guide shows approximately 10 ft x 10 ft (3.0 x 3.0 m) coverage at 8 to 11 ft (2.4 to 3.4 m) mounting height.
Why this product exists
This model gives buyers a 4000W radiant heating option in a long single-element format for projects that need focused outdoor comfort heat without gas piping. It is intended for installations where electric infrared heat, minimal visual bulk, and a painted white body are preferred.
Compared with similar products
Compared with lower-wattage patio heaters, this 4000W model is typically selected for larger seating areas or higher mounting conditions. Compared with dual-element models, a single-element W-Series heater offers a longer body profile and is commonly used where straightforward control and a linear appearance are preferred. As a rule of thumb, a 4000W load at 240V draws about 16.7A, so branch circuit and control selection should be checked against continuous-load requirements and local electrical code. Actual performance depends on installation conditions, layout, and exposure.
Specifications
- Brand: Infratech
- Manufacturer part number: W-4024-SS-WH
- Series: W-Series
- Product type: Single element electric infrared patio heater
- Colour/finish: White body
- Construction: 304 stainless steel heater construction
- Wattage: 4000W
- Voltage: 240V
- Current: 16.7A
- Length: 61-1/4 in (1556 mm)
- Application: Residential and commercial outdoor comfort heating
- Typical planning coverage: approximately 10 ft x 10 ft (3.0 x 3.0 m)
- Typical mounting height for W-40 planning: 8 to 11 ft (2.4 to 3.4 m)
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.