Single Element Infrared Patio Heater · 3000W 208V · 61-1/4 in with Beige Finish · Infratech W-3028-SS-BE
What this product is for
This electric infrared radiant heater is used to warm people and surfaces in covered outdoor or indoor/outdoor spaces where gas heat is not preferred. It is a single-element Infratech W-Series unit rated 3000W at 208V, in a 61-1/4 in (155.6 cm) body with a beige finish.
Use for
Use for patios, terraces, pergolas, covered balconies, restaurant seating areas, and similar residential or light commercial spaces. It is commonly selected where electricians or contractors need a hardwired radiant heater that can be wall, ceiling, pole, or flush mounted with the appropriate accessories and clearances.
Avoid for
Avoid using this heater as whole-room space heating or in open, high-wind areas where radiant performance drops quickly. Do not treat estimated coverage as a guaranteed output for every site, and do not use it on the wrong supply voltage.
Best for
Best for projects needing a long single-element heater for focused radiant comfort, especially where a flush-mount-friendly W-Series body is preferred. The beige housing can also suit architectural finishes where stainless steel is not the desired visible colour.
Installed in
Typically installed in covered outdoor living areas, hospitality patios, screened porches, and commercial seating zones. Infratech lists these heaters for permanent hardwired installation by a licensed electrician, with indoor/outdoor use and mounting options including flush, ceiling, wall, and pole mounting when installed to manufacturer instructions.
Why this product exists
This model provides electric radiant comfort heat without flame, fumes, or blower noise. It is intended for projects that need 208V power, a slim linear heater format, and compatibility with Infratech control options. As a rule of thumb, 3000W patio heaters are often laid out for approximately 64 sq ft (about 5.9 m²) in favourable covered conditions. Actual performance depends on mounting height, wind, ambient temperature, layout, and local electrical code.
Compared with similar products
Compared with shorter 39 in (99.1 cm) W-Series models, this 61-1/4 in unit is used where a longer heater body and 3000W output are needed. Compared with dual-element Infratech models, this single-element version is a simpler fit for many residential and light commercial layouts. Compared with 240V versions, this 208V model must be matched to the correct supply and control design.
Specifications
- Brand: Infratech
- Manufacturer part number: W-3028-SS-BE
- Series: W-Series
- Product type: Single-element electric infrared radiant heater
- Wattage: 3000W
- Voltage: 208V
- Current: 14A
- Length: 61-1/4 in (155.6 cm)
- Replacement element length: 58 in (147.3 cm)
- Finish: Beige
- Base platform/model reference: W-3028 SS
- Mounting: Wall, ceiling, pole, or flush mount with compatible accessories
- Installation: Permanent hardwired installation
- Suggested mounting guidance: commonly installed around 8 to 10 ft (2.4 to 3.0 m), subject to manufacturer instructions and site design
- Warranty: 3-year manufacturer warranty
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
Standard Shipping-Free on orders over $500 in Metropolitan Areas / Subject to $750 in Rural Areas.
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998(Updated August 2026)
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.