Infrared Patio Heater · 2000W 208V · Single Element Bronze Stainless Steel · Infratech W-2028-SS-BR
What this product is for
This electric infrared patio heater is used to provide directional radiant heat in outdoor and semi-outdoor spaces such as covered patios, restaurant seating areas, balconies and work areas where overhead electric heating is preferred.
It is a W-Series single-element Infratech heater with a bronze body and stainless steel trim, rated 2000W at 208V.
Use for
- Covered patios and decks
- Outdoor dining and hospitality seating
- Residential backyard living spaces
- Light commercial exterior waiting or gathering areas
- Installations where a compact 39 in (991 mm) heater length fits the available mounting space
Avoid for
- Indoor comfort heating for whole-room space heating
- Applications requiring broad-area heat coverage from a single small heater
- Installations where the available supply voltage does not match 208V
- Open, windy locations where radiant heat retention is limited
Best for
Best for electricians and contractors specifying a fixed-mount electric infrared heater for targeted occupant warmth rather than air heating. This model is commonly selected where wall or ceiling space is limited and a shorter single-element heater is preferred.
Installed in
Typically installed in covered outdoor residential and commercial areas, including patios, pergolas, verandas, restaurant terraces and similar spaces. The heater body length is approximately 39 in (991 mm), which helps when planning around beams, soffits and ceiling layouts.
Why this product exists
Infrared patio heaters are used where fast, directional comfort heat is needed without relying on forced air or fuel cylinders. This 208V single-element model gives specifiers an option for buildings with 208V power and for layouts that do not require a larger dual-element heater.
Typical guidance only: 208V electric heaters generally deliver less heat output than comparable 240V versions of the same wattage family, so coverage should be estimated based on mounting height, exposure and occupancy pattern. Actual performance depends on installation conditions, wind exposure, mounting layout and local electrical code.
Compared with similar products
- Compared with dual-element heaters: this single-element unit is shorter and suited to smaller zones, but it will not cover as large an area as higher-wattage dual-element models.
- Compared with 240V versions: this model is specifically for 208V supply, which is common in some commercial buildings.
- Compared with gas patio heaters: electric infrared heat is commonly chosen where fixed wiring, clean appearance and no on-site fuel storage are preferred.
Specifications
- Brand: Infratech
- Manufacturer part number: W-2028-SS-BR
- Series: W-Series
- Product type: Single-element electric infrared patio heater
- Rated power: 2000W
- Voltage: 208V
- Current: 10A
- Heater length: 39 in (991 mm)
- Finish: Bronze body with stainless steel trim
- Application: Outdoor and semi-outdoor radiant comfort heating
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.