Infrared Patio Heater · 2000W 208V · Single Element Black 39 in (991 mm) · Infratech W-2028-SS-BL
What this product is for
The Infratech W-2028-SS-BL is a 2000W, 208V single-element electric infrared heater for indoor or outdoor comfort heating. It is designed to warm people and surfaces directly rather than heating surrounding air, which makes it a practical choice for covered patios, balconies, garages, workshops, and light commercial seating areas.
Use for
Use this heater where 208V power is available and you need focused radiant heat in a compact 39 in (991 mm) body. It is suitable for wall or ceiling mounting and is also a common choice where flush-mount installations are being considered.
Avoid for
Avoid using this model where only 240V heater sizing has been planned, or where broad-area heating requires a larger coverage pattern. Do not assume a 240V model will perform the same on 208V supply; voltage must match the heater rating.
Best for
Best for small to medium seating or standing zones that need clean electric radiant heat without gas lines or open flame. This black finish is also a fit for darker soffits, pergolas, and commercial exterior designs where the heater should blend into the background.
Installed in
Typically installed in covered patios, restaurant patios, condo balconies, garages, workshops, and enclosed or semi-exposed outdoor living areas. Typical mounting height for this W-Series size is about 7 to 8 ft (2.1 to 2.4 m), depending on layout and clearance requirements.
Why this product exists
This model gives contractors and specifiers a 208V W-Series option in a 39 in format for projects where service voltage is already 208V. It provides targeted radiant comfort heat with a slimmer installation footprint than many gas-fired patio heating options, and it is listed for indoor and outdoor use.
Compared with similar products
Compared with larger radiant heaters, this 2000W single-element model is better suited to smaller zones and tighter wall space. Compared with a 240V version, this is the correct choice when the site power is 208V. As a rule of thumb, this size is commonly used for approximately 6 x 6 ft (1.8 x 1.8 m) coverage at about 7 to 8 ft mounting height. Actual comfort coverage depends on wind, mounting location, ambient temperature, and surrounding construction.
Specifications
- Brand: Infratech
- Manufacturer part number: W-2028-SS-BL
- Series: W-Series
- Product type: Electric infrared radiant heater
- Element type: Single element
- Wattage: 2000W
- Voltage: 208V
- Current: 10A
- Length: 39 in (991 mm)
- Approximate dimensions: 39 x 8 x 3 in (991 x 203 x 76 mm)
- Finish: Black
- Construction: 304 stainless steel body with colour finish
- Mounting: Surface mount or flush mount
- Typical mounting height: 7 to 8 ft (2.1 to 2.4 m)
- Typical coverage guidance: approximately 6 x 6 ft (1.8 x 1.8 m)
- Certifications: UL and cUL listed; IPX4 rated
- Application: Indoor and outdoor use
Coverage and mounting guidance are typical trade-level estimates only. Actual performance depends on installation conditions, exposure, mounting height, insulation, layout, and local electrical code.
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.