Single Element Infrared Patio Heater · 2000W 208V · 39 in Beige Stainless Steel · Infratech W-2028-SS-BE
What this product is for
This single-element infrared heater is used to provide directional radiant heat in covered patios, restaurant seating areas, balconies, pergolas, and similar indoor or outdoor spaces where electric infrared heat is preferred over gas-fired equipment. It is part of the Infratech W-Series and is built as a 2000W, 208V heater with a beige stainless steel body.
Use for
Use for spot heating seating areas, work areas, and small outdoor zones where clean electric infrared heat is needed. It is commonly selected where a 208V supply is available and where a compact 39 in (991 mm) heater fits the mounting space.
- Covered patios and outdoor dining areas
- Residential decks, pergolas, and screened spaces
- Indoor commercial or residential supplementary heat
- Projects requiring a beige finish instead of standard stainless appearance
Avoid for
Avoid using this heater as whole-room primary heating, in open windy areas where radiant effectiveness drops, or where only 240V power is available without confirming compatibility. Do not assume outdoor comfort coverage from wattage alone.
Best for
Best for electricians and contractors specifying a compact infrared heater for smaller seating zones or installations with limited wall or ceiling space. This model suits projects where finish colour matters and where a single-element heater is sufficient for the target area.
Installed in
Typically installed on wall, ceiling, pole, or flush-mount compatible layouts where permitted by the manufacturer instructions and required clearances. Common installations include covered residential patios, condo balconies, hospitality spaces, and light commercial outdoor areas.
Why this product exists
This product exists for applications that need focused radiant heat without open flame, fuel storage, or combustion by-products. Compared with larger dual-element models, a 2000W single-element unit is commonly used where wall space is limited or where the heated zone is smaller.
Typical guidance: on 208V systems, heater output is generally lower than comparable 240V applications, so designers often review mounting height, exposure, and the number of heaters required before final selection. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Compared with similar products
Compared with higher-wattage or dual-element infrared heaters, this model is shorter and intended for smaller zones. Compared with gas patio heaters, electric infrared heaters are commonly chosen where silent operation, no open flame, and a cleaner visual profile are preferred. If the project has more exposure to wind or a larger seating area, a higher wattage or multiple-heater layout may be more appropriate.
Specifications
- Brand: Infratech
- Manufacturer part number: W-2028-SS-BE
- Series: W-Series
- Product type: Single-element electric infrared patio heater
- Wattage: 2000W
- Voltage: 208V
- Current: approximately 9.6A
- Length: 39 in (991 mm)
- Housing finish: Beige
- Housing material: Stainless steel
- Application: Indoor and outdoor use, subject to manufacturer installation requirements
- Mounting: Commonly used in wall, ceiling, pole, or flush-mount heater layouts where approved
- Listing: UL listed for indoor/outdoor use based on distributor/manufacturer literature
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.