Slimline Single Element Infrared Heater · 2400W, 208V, 42-1/2 in (1080 mm) · Stainless Steel Outdoor Unit · Infratech SL-2428
What this product is for
The Infratech SL-2428 is a slimline single-element infrared heater for spot and zone heating in outdoor living areas, covered patios, restaurant seating, and similar commercial or residential spaces. It is a 208V model rated 2400W and 11.5A with a 42-1/2 in (1080 mm) body.
Use for
Use for surface-mounted radiant heat where a narrow-profile heater is needed and the available supply is 208V. Suitable for patios, pergolas, covered decks, hospitality seating areas, and other installations where direct infrared heat is preferred over forced air.
- 208V heating circuits
- Outdoor or indoor covered applications where the installation manual is followed
- Mounting heights typically up to 10 ft (3.0 m), depending on layout and comfort target
Avoid for
Avoid using this heater where only 240V supply is available unless the exact heater voltage matches the project design. Do not use where clearance, mounting orientation, or weather exposure falls outside the manufacturer instructions. Not intended as whole-room space heating for enclosed interiors.
Best for
Best for electricians and contractors specifying a clean-looking infrared heater for narrower wall or ceiling runs. The slimline housing and single-element format suit smaller seating zones and projects where appearance matters as much as heat placement.
Installed in
Typically installed in covered residential patios, condo amenity spaces, restaurants, clubs, and light commercial outdoor gathering areas. A practical rule of thumb is to match heater selection to mounting height, wind conditions, and occupied zone size rather than floor area alone. Actual comfort performance depends on installation conditions, insulation, layout, and local electrical code.
Why this product exists
This model provides directional radiant heat without moving air, making it useful where occupants need warmth in open or semi-open spaces. Compared with bulkier heaters, the SL-Series is designed with a narrow profile, stainless steel trim, and flexible mounting via the series T-slot system.
Compared with similar products
Compared with larger dual-element patio heaters, the SL-2428 is a lower-wattage single-element option for smaller zones or tighter mounting spaces. Compared with 240V versions, this 208V model is intended for buildings and commercial services using 208V power, so voltage matching is important at the design stage.
Specifications
- Brand: Infratech
- Manufacturer part number: SL-2428
- Product family: SL-Series Slimline
- Type: Single-element infrared electric heater
- Application: Outdoor / indoor covered radiant heating
- Rated power: 2400W
- Voltage: 208V
- Current: 11.5A
- Length: 42-1/2 in (1080 mm)
- Replacement element reference: E-2428-SL
- Finish/material: Standard stainless steel / stainless trim
- Mounting guidance: Surface mount applications, with mounting heights up to 10 ft (3.0 m) referenced by manufacturer family literature
- Installation note: Heater must be installed horizontally level per manufacturer manual
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.