Infrared Patio Heater · 1600W 120V · Single Element Black Slimline · Infratech SL-1612-BK
What this product is for
This electric infrared radiant heater is used for targeted comfort heat in residential and light commercial spaces such as patios, balconies, screened rooms, and covered outdoor seating areas. The slimline single-element design suits applications where wall or ceiling space is limited and a clean black finish is preferred.
Use for
Use for spot heating people and occupied zones rather than trying to heat the surrounding air. Common installations include covered patios, pergolas, enclosed porches, restaurant seating areas, and indoor spaces where silent radiant heat is preferred.
Avoid for
Avoid using this heater as whole-room space heating for large open areas or exposed locations with significant wind. It is also not the right choice where a higher-voltage or higher-wattage heater is needed for larger coverage zones.
Best for
Best for electricians and contractors specifying a compact 120V infrared heater for smaller zones, retrofit projects, or locations where a 120V circuit is already available. A 120V, 1600W load draws approximately 13.3A, so branch-circuit planning should follow applicable code and continuous-load requirements.
Installed in
Typically installed on wall or ceiling surfaces in covered outdoor living areas, hospitality spaces, workshops, and enclosed residential rooms. The heater body is approximately 29.5 in long (750 mm), 4.75 in wide (121 mm), and 3 in high (76 mm), which helps when laying out tight mounting locations.
Why this product exists
This model exists for projects that need focused radiant heat from a compact single-element heater instead of a larger dual-element unit. Infrared heaters warm people and surfaces directly, which is commonly preferred for patios and semi-exposed spaces where forced-air heat is less effective.
Compared with similar products
Compared with larger 240V patio heaters, this 120V 1600W model is better suited to smaller heating zones and simpler electrical service access. Compared with gas patio heaters, electric infrared units provide silent operation with no open flame at the point of use. As a rule of thumb, heater selection should be based on occupancy area, mounting height, exposure, and layout rather than wattage alone. Actual performance depends on installation conditions, insulation, layout, and local electrical code.
Specifications
- Brand: Infratech
- Manufacturer part number: SL-1612-BK
- Series: SL-Series Slimline
- Product type: Single-element electric infrared radiant heater
- Wattage: 1600W
- Voltage: 120V
- Current: approximately 13.3A
- Finish/colour: Black
- Mounting: Surface mount, wall or ceiling applications
- Approximate dimensions: 29.5 in x 4.75 in x 3 in (750 x 121 x 76 mm)
- Application: Indoor/outdoor comfort heating in covered or protected areas
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.