Dual Surface-Mount On/Off Switch · 120/277 VAC 20A per switch · Weatherproof box · Infratech 14-4425
What this product is for
This is a dual surface-mount on/off switch assembly with a weatherproof box for controlling compatible Infratech radiant heaters in outdoor or exposed locations. It provides two independent on/off switches in one assembly where in-wall mounting is not practical.
Use for
Use for outdoor patio heater control points, covered commercial patios, restaurant terraces, residential outdoor living areas, and other installations using compatible Infratech C-Series, SL-Series, or W-Series heaters. It is suited to surface-mounted installations where weather protection for the switch assembly is required.
Avoid for
Avoid using this as a dimmer or variable heat control, or where a flush in-wall control is required. Do not use beyond the stated electrical rating, and do not assume one switch can control more load than the manufacturer allows.
Best for
Best for electricians and contractors needing a straightforward outdoor heater control with independent switching in a single weatherproof assembly. It is a practical choice when wall construction, retrofit conditions, or exterior finishes make recessed mounting difficult.
Installed in
Typically installed on exterior walls, posts, service areas, and outdoor living spaces. Approximate overall size is 5.5 in. x 3.63 in. x 2.25 in. (140 x 92 x 57 mm), which helps when planning surface clearances and conduit entry.
Why this product exists
This control assembly exists to provide simple, separate on/off control for two heater circuits or elements in a weather-protected surface-mount format. For many outdoor heater layouts, a basic switch assembly is the most direct control method and can simplify operation and service access.
Compared with similar products
Compared with flush-mount switch kits, this model is intended for surface installation and includes a weatherproof box for exposed locations. Compared with timer or dimmer-based controls, it offers basic on/off operation only. As a typical rule of thumb, simple on/off controls are commonly selected where staged heat control is not required and straightforward switching is preferred. Actual control suitability depends on heater configuration, circuit design, and local electrical code.
Specifications
- Manufacturer: Infratech
- Part number: 14-4425
- Product type: Dual surface-mount on/off switch assembly
- Mounting: Surface mount
- Enclosure: Weatherproof box with cover
- Electrical rating: 120/277 VAC
- Maximum current: 20A per switch
- Typical maximum load: up to 3000W at 208/220V per switch; up to 4000W at 240/277V per switch
- Compatible heater families: Infratech C-Series, SL-Series, W-Series
- Material: Steel J-box, stainless cover, plastic switch body
- Finish/colour: Stainless steel
- Approximate size: 5.5 in. x 3.63 in. x 2.25 in. (140 x 92 x 57 mm)
- Country of manufacture: USA
- Warranty: 3-year manufacturer warranty
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.