Infrared Patio Heater · 4000W 240V 39 in · Dual Element Stainless Steel · Infratech WD-4024-SS
WD-4024-SS
1095
– Loyalty Rewards
:
from
to
Clear
Clear
Dual duplex switch wall plate · stainless steel faceplate with gang box · flush mount heater control · Infratech 14-4305
SKU: 14-4305
Flush-mount dual duplex switch assembly for Infratech radiant heater control, supplied with a stainless steel wall plate and gang box. Commonly used to control dual-element Infratech heaters in indoor or protected outdoor installations; verify load and switch rating before ordering.
What this product is for
This control accessory is a flush-mount dual duplex switch assembly for compatible Infratech radiant heating systems. It includes a stainless steel wall plate, gang box, and dual stacked duplex switching for a clean finished installation.
Use for
Use for switching compatible dual-element Infratech heaters where separate on/off control is required. It is commonly used in indoor areas or protected outdoor spaces such as covered patios, hospitality seating areas, and residential outdoor living zones.
Avoid for
Avoid using this control where a weatherproof surface-mount assembly is required, or where the connected heater load exceeds the switch rating. Do not assume compatibility with non-Infratech systems without confirming electrical requirements and control layout.
Best for
Best for projects needing a built-in wall control with a stainless steel finish to match premium patio heater installations. It suits electricians and contractors looking for a manufacturer-matched control for dual-element heater circuits.
Installed in
Typically installed in a wall cavity using the included gang box and finished with the stainless steel faceplate. Product dimensions are approximately 4.88 x 4.94 x 1.56 in (124 x 125 x 40 mm).
Why this product exists
This assembly provides a cleaner flush-mount alternative to exposed switching hardware while allowing staged or separate control of compatible heater elements. For radiant heater controls, matching the switch assembly to the heater configuration helps simplify specification and finishing.
Compared with similar products
Compared with single-switch wall controls, this dual duplex assembly is intended for applications needing more than one switching function. Compared with weatherproof surface-mount versions, this model is designed for flush-mount use and is better suited to finished walls in indoor or protected outdoor locations.
Typical trade guidance: line-voltage heater controls must be matched to the connected voltage and amperage. Actual performance and suitability depend on heater model, wiring method, installation conditions, and local electrical code.
Specifications
- Manufacturer: Infratech
- Manufacturer part number: 14-4305
- Product type: Dual duplex switch wall plate with gang box
- Mounting style: Flush mount / in-wall
- Finish material: Stainless steel wall plate
- Included components: Stainless steel wall plate, gang box, dual duplex switches
- Application: Control accessory for compatible Infratech radiant heaters
- Electrical rating: 120/277 VAC, 20 A maximum per switch
- Approximate dimensions: 4.88 x 4.94 x 1.56 in (124 x 125 x 40 mm)
- Typical installation area: Indoor or protected outdoor areas
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.
Related products
Available to Order | Typically Arrives in 1 - 3 Weeks From California USA