:
from
to
Clear
Clear
Magnetic LED Driver · 200W 24V DC · Dimmable · Axite Lighting Canada EM200S24DC
SKU: EM200S24DC
200W magnetic LED driver with 24V DC output for constant-voltage LED strip and low-voltage lighting systems. Dimmable design for indoor or outdoor low-voltage applications; typical sizing practice is to leave headroom on total connected load. Actual performance depends on dimmer compatibility, wiring layout, and installation conditions.
What this product is for
This 200W magnetic LED driver converts 120V AC input to 24V DC output for constant-voltage LED lighting systems. It is intended for LED strip, ribbon, and other 24V DC low-voltage lighting loads where dimming is required.
Use for
Use for 24V DC LED strip installations, cove lighting, under-cabinet lighting, display lighting, and indoor or outdoor low-voltage lighting systems that require a dimmable magnetic driver. It is commonly selected where contractors want a hardwired driver for larger 24V loads.
Avoid for
Avoid using this driver with constant-current LED fixtures, non-24V DC products, or loads that exceed the rated output. Do not assume universal dimmer compatibility without checking the connected control and fixture requirements.
Best for
Best for electricians and lighting contractors powering longer 24V LED strip runs or higher-wattage constant-voltage lighting zones from a single dimmable driver. As a rule of thumb, many installers leave capacity headroom rather than loading a driver to the full nameplate rating continuously.
Installed in
Typically installed in residential millwork, commercial accent lighting, retail displays, hospitality lighting, and exterior low-voltage lighting layouts where a 24V DC dimmable power supply is required. Product references indicate indoor/outdoor suitability on comparable EM200S24DC listings.
Why this product exists
24V DC lighting systems need a compatible constant-voltage power source between the branch circuit and the LED load. A magnetic dimmable driver like this is used where stable low-voltage output and wall-dimmer-based control are needed for larger lighting loads.
Compared with similar products
Compared with smaller 24V drivers, a 200W unit supports larger lighting zones and can reduce the number of power supplies required on a project. Compared with electronic drivers, magnetic drivers are often chosen when the specification or dimming method calls for a magnetic low-voltage style driver. Typical LED strip guidance is to confirm total wattage, voltage drop, and dimmer compatibility before final selection.
Estimated guidance only: actual performance depends on installation conditions, conductor size, run length, connected load, and local electrical code.
Specifications
- Type: Magnetic LED driver
- Manufacturer part number: EM200S24DC
- Brand: Axite Lighting Canada
- Rated power: 200W
- Output voltage: 24V DC
- Dimming: Yes
- Application: Constant-voltage LED lighting
- Typical input voltage on comparable EM200S24DC listings: 120V AC, 60 Hz
- Typical max output current on comparable EM200S24DC listings: 8.3A
- Typical dimensions on comparable EM200S24DC listings: 9.19 in x 3.94 in x 1.63 in (233 x 100 x 41 mm)
- Typical environment listing on comparable EM200S24DC listings: indoor/outdoor
- Typical certification shown on comparable EM200S24DC listings: cUL Listed
- Watts200W
- FinishBlack
- Mounting TypePost or Wall Mount
- Volts24V DC
- TypeMagnetic
- LocationOutdoor
- Height8.79"
- Width4.15"
- Depth3.41"
- BrandAxite Lighting Canada
- Warranty5 year
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.
Related products
- Edmonton Stock: 396
- Edmonton Stock: 134
- Edmonton Stock: 81
- Edmonton Stock: 8
MLE200-24DC-UD AXITE LIGHTING 200W 24V DIMMABLE 5 IN 1 LED DRIVER
MLE200-24DC-UD
Available For Backorder400 – Loyalty Rewards- Edmonton Stock: 5
