1600 Lumens 14W Watts A19 Frosted LED 3000K Medium Base (4/Pack) Satco Lighting S11423
What this product is for
This A19 LED lamp is for retrofit use in standard 120V fixtures with an E26 medium base where you need soft white general lighting and dimming. It is suited to table lamps, ceiling fixtures, wall lights, and enclosed fixtures rated for this lamp type.
Use for
Use for living areas, bedrooms, hallways, kitchens, offices, and other indoor damp-location fixtures requiring approximately 1600 lumens. It is commonly selected where a contractor or maintenance buyer wants LED energy savings with light output in the typical 100W incandescent replacement range.
Avoid for
Avoid for non-dimmable controls that are known to be incompatible with forward-phase dimming, open outdoor locations, or applications requiring a higher CRI or specialty beam control. Do not assume identical dimming performance across all dimmers.
Best for
Best for general service lighting upgrades where a frosted A19 lamp, medium base, and warm 3000K colour temperature are required. The 4-pack is practical for room-by-room relamping and small maintenance stock.
Installed in
Typically installed in residential and light commercial fixtures using a standard E26 socket. Lamp size is about 4.57 in overall length (116 mm) with a maximum diameter of 2.38 in (60 mm), which helps when checking fit in enclosed or decorative fixtures.
Why this product exists
This lamp provides LED efficiency and reduced relamping compared with incandescent lamps while keeping the familiar A19 shape and medium base. With a rated life of 15,000 hours, it is intended to lower maintenance in everyday lighting applications.
Compared with similar products
Compared with lower-lumen A19 lamps, this 1600-lumen model is better suited where stronger general illumination is needed. As a rule of thumb, residential spaces often target about 10 to 20 lumens per sq ft, so one lamp of this output may suit smaller rooms or supplement layered lighting; actual performance depends on fixture design, mounting height, surface reflectance, and local electrical code.
Specifications
- Manufacturer part number: S11423
- Brand: Satco
- Lamp type: A19 LED lamp
- Pack size: 4-pack
- Wattage: 14W
- Voltage: 120V
- Light output: 1600 lm
- Colour temperature: 3000K soft white
- Base: E26 medium base
- Finish: Frosted
- Dimmable: Yes, forward phase
- Beam angle: 230°
- CRI: 80+
- Incandescent equivalent: 100W typical replacement
- Rated life: 15,000 hours
- Location rating: Damp
- Enclosed fixture rated: Yes
- Operating temperature: -4°F to 113°F (-20°C to 45°C)
- Maximum overall length: 4.57 in (116 mm)
- Maximum diameter: 2.38 in (60 mm)
- Safety listing: cULus listed/certified
- Warranty: 2 years
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.