60 Watt 24V DC Dimmable Electronic Driver MLE60-24DC-P
MLE60-24DC-P
102
– Loyalty Rewards
60 Watt 24V DC Dimmable Magnetic Driver ML60S24DC
60W magnetic LED driver with 24V DC constant-voltage output for dimmable LED strip and low-voltage lighting applications. Commonly used where phase-dimmable magnetic drivers are required; as typical guidance, size LED driver loads with headroom rather than running continuously at full output.
Delivered to you by May 15 (Within Western Canada)
If shipping issues arise, contact us and we’ll work with the courier to keep your job on track.
What this product is for
This 60W magnetic LED driver converts 120V AC input to 24V DC constant-voltage output for compatible dimmable LED lighting systems. It is suited to LED strip, ribbon, under-cabinet, cove, display, and other low-voltage lighting layouts that require a 24V DC magnetic driver.
Use for
Use for 24V DC LED strip and other constant-voltage LED loads up to 60W. It is commonly selected for residential and light commercial dimming applications where a magnetic, phase-dimmable driver is specified.
Avoid for
Avoid using this driver with constant-current LED products, non-dimmable-only systems where a dimmable magnetic driver is not required, or loads that exceed the 60W rating. Do not use it where the fixture or tape light manufacturer specifies a different output voltage.
Best for
Best for electricians and lighting installers matching 24V DC tape light or accent lighting to a magnetic dimming system. As a typical rule of thumb for LED strip, allowing some capacity headroom can help with thermal management and long-term reliability. Actual performance depends on installation conditions, total connected load, dimmer compatibility, and local electrical code.
Installed in
Typically installed in millwork lighting, under-cabinet runs, shelving, display lighting, coves, and other indoor low-voltage lighting systems. Confirm enclosure, ventilation, and location requirements before installation.
Why this product exists
This product provides a dimmable magnetic power solution for 24V DC LED systems where compatibility with specified magnetic dimming controls or existing low-voltage lighting layouts is important.
Compared with similar products
Compared with non-dimmable drivers, this model is intended for installations requiring light-level control. Compared with electronic drivers, a magnetic driver may be chosen when the lighting design, dimmer type, or replacement requirement specifically calls for a magnetic unit. For LED strip, 24V systems are also commonly preferred over 12V for longer runs because voltage drop is typically easier to manage, though actual run length depends on wattage and conductor size.
Specifications
- Manufacturer part number: ML60S24DC
- Brand: Axite Lighting Canada
- Product type: Magnetic LED driver
- Rated power: 60W
- Output voltage: 24V DC
- Input voltage: 120V AC
- Dimming: Dimmable, magnetic/phase-dimming application
- Output type: Constant voltage
- Typical full-load output current: approximately 2.5A at 24V DC
- Typical application: 24V LED strip and low-voltage lighting
- Approximate housing size seen on comparable ML60S24DC listings: 8.13 in x 3.93 in x 1.59 in (206 x 100 x 40 mm). Verify against the final submittal before ordering.
- Watts60W
- FinishBlack
- Mounting TypePost or Wall Mount
- Volts24V DC
- TypeMagnetic
- LocationOutdoor
- Height8.13"
- Width3.93"
- Depth1.59"
- BrandAxite Lighting Canada
- Warranty5 year
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.
Related products
Available to Order | Typically Arrives in 1 - 3 Weeks- Edmonton Stock: 11
- Edmonton Stock: 14
- Edmonton Stock: 10
LED ribbon power feed clip · for 1W or 3W ribbon · clip-style power connection · Axite Lighting H8W1
H8W1
Restocking2 – Loyalty Rewards3 w/ft Under Cabinet LED Strip - 254 lm/ft · 3000K · 24V · 16 ft
EV3-IN-16-24V-3000
Restocking89 – Loyalty Rewards
