- Edmonton Stock: 7
:
from
to
Clear
Clear
20 Watt 24V DC Dimmable Magnetic Driver ML20S24DC
SKU: ML20S24DC
20W magnetic LED driver with 24V DC constant-voltage output for compatible LED strip and low-voltage lighting loads. Dimmable and suitable for indoor or outdoor use where a magnetic driver is required; as typical guidance, keep connected load below the full rated wattage to allow installation margin. Actual performance depends on dimmer compatibility, wiring layout, and installation conditions.
Delivered to you by Aug 17 (Within Western Canada)
If shipping issues arise, contact us and we’ll work with the courier to keep your job on track.
What this product is for
This 20W magnetic LED driver converts 120V AC input to 24V DC constant-voltage output for compatible low-voltage LED lighting systems. It is intended for smaller 24V LED strip, ribbon, and accent lighting runs where dimming and a magnetic driver format are required.
Use for
- 24V DC LED strip and ribbon lighting
- Indoor or outdoor low-voltage lighting installations
- Projects using compatible magnetic low-voltage dimming controls
- Small lighting loads up to the driver rating
Avoid for
- Constant-current LED fixtures
- 12V DC lighting systems
- Loads exceeding 20W
- Applications where dimmer compatibility has not been confirmed
Best for
Best for electricians and lighting installers needing a compact 24V magnetic driver for short LED strip runs, accent lighting, and other low-voltage applications where dimming is required and indoor/outdoor rating matters.
Installed in
Typically installed in residential and light commercial LED strip systems, display lighting, cove lighting, and exterior low-voltage lighting layouts. The housing is listed for indoor/outdoor use, with dimensions of approximately 7.4 in x 2.1 in x 1.5 in (189 x 54 x 38 mm), which helps when planning enclosure or mounting space.
Why this product exists
It provides a dimmable 24V DC power source for low-wattage LED loads where a magnetic driver is preferred for compatibility or project standardization. For buying guidance, installers commonly leave some headroom rather than loading a driver to 100% continuously. Actual performance depends on dimmer selection, connected load, cable length, and local electrical code.
Compared with similar products
Compared with higher-wattage 24V magnetic drivers, this 20W model is better suited to smaller loads and tighter spaces. Compared with non-dimmable drivers, it supports light-level control when paired with compatible dimmers. Compared with electronic drivers, a magnetic driver may be selected where the project specifically calls for that driver type.
Specifications
- Manufacturer part number: ML20S24DC
- Brand: Axite Lighting Canada
- Product type: Magnetic LED driver
- Input voltage: 120V AC, 60 Hz
- Output voltage: 24V DC constant voltage
- Maximum load: 20W
- Maximum output current: 0.8A
- Dimmable: Yes
- Dimming range: 0-100%
- Driver type: Magnetic low voltage
- Use location: Indoor / outdoor
- Environmental rating: NEMA 3R / NEMA 4X references appear across seller listings; confirm project requirement before ordering
- Protection: Thermal self-reset breakers on primary and secondary side
- Dimensions: approximately 7.44 in x 2.11 in x 1.5 in (189 x 54 x 38 mm)
- Warranty: 5 years
- Certification: cUL Listed
- Watts20W
- FinishBlack
- Mounting TypePost or Wall Mount
- Volts24V DC
- TypeMagnetic
- LocationOutdoor
- Height7..38"
- Width2.11"
- Depth1.6"
- BrandAxite Lighting Canada
- Warranty5 year
Minimum Order $20
We accept the following payment methods:
Credit Card can offer cardholders convenience, security, rewards, and the opportunity to build a healthy credit history.
Click here for Contractor Cash Account
Trade Credit is a standard financing option for contractors and construction companies to obtain supplies and keep their projects moving. We offer 30-day credit terms to trade contractors on approved applications only.
Click here for Contractor Credit Account 
(Contractor Accounts)
Standard Shipping-Free on orders over $249 in Metropolitan Areas / $499 in Rural Areas
(All Other Accounts)
Standard Shipping-Free on orders over $499
Minimum Order Is $20
Freight Surcharge Apply To Oversized/Over-Weight Items(Not Limited To):
- PVC and EMT Pipe
- Wire and Cable
- Items over 48 inches in length
Surcharges are applied to items on an individual basis regardless if the rest of the order meets prepaid levels. If a freight line appears at the time of check out it only applies to the Items carrying a surcharge and not the entire basket of goods.
Shipping Options:
- A courier can deliver to your home, office, or your job site
- Pick up at local depot near you (applies to the following locations)
Edmonton Warehouse 8135 Roper Rd Edmonton, T6E 6S4, AB
Burnaby Warehouse 5608 Goring St Burnaby, V5B 3A3, BC
Orders are typically delivered within two to eleven business days. The transit time begins the first full shipping day after your order leaves our warehouse. Please allow an additional 2-5 days for delivery to remote locations, additional fees may apply.
THE FOLLOWING APPLIES TO STANDARD SHIPPING OPTIONS
- We cannot deliver to P.O. boxes.
- A signature may be required for shipments over $500.
- No weekend delivery.
- Wire & cable, EMT or PVC conduit, tube lamps 4ft or greater, and 10ft ground rods & mast pipes have special conditions.
Standard Shipping cost on orders less than $499
Total shipping cost = "Per Shipment" cost + "Per Item" cost. The "per item" cost is listed in terms of price per pound.
Product Group | Per Shipment* | Per Item |
|---|---|---|
Boxes | $6.99 | $1.49/lb |
Conduit & Raceway | $149.99 | $2.49/lb |
Connectors & Fittings | $5.99 | $1.19/lb |
Data & Structured Home | $5.99 | $1.19/lb |
Distribution Equipment | $5.99 | $1.19/lb |
Emergency Lighting | $6.99 | $1.49/lb |
Heating & Ventilation | $6.99 | $1.49/lb |
Lighting Controls | $5.99 | $1.19/lb |
Lighting Indoor | $6.99 | $1.49/lb |
Lighting Outdoor | $6.99 | $1.49/lb |
Tools | $4.99 | $.99/lb |
Wire & Cable | $49.99 | $2.29/lb |
Wiring Devices | $5.99 | $1.19/lb |
Any combination of the above items | Highest applicable per-shipment charge | As above |
Effective Date: August, 15, 1998
At Evolt Electrical Supply, customer satisfaction is our top priority. Please review our return policy below:
Returns
Defective Items:
- If you receive a defective item, you may return it for a replacement or refund within 30 days of purchase.
- To initiate a return, please contact our customer service team with your order number and a description of the defect.
Non-Defective Items:
- We do not accept returns for non-defective items. All sales are final once the product is shipped or ordered from the manufacturer. In certain circumstances we may amend this so feel free to contact our customer service team.
Return Process
Authorization:
- Before returning any items, you must obtain a Return Merchandise Authorization (RMA) number from our customer service team. Returns without an RMA number will not be accepted.
- Backordered items can not be cancelled if the item is in transit from the manufacturer, contact us to review.
Shipping:
- Customers are responsible for the return shipping costs. We recommend using a trackable shipping service or purchasing shipping insurance.
Condition:
- Returned items must be in their original packaging and condition. Any items returned damaged due to improper packaging or misuse will not be eligible for a refund or replacement.
Refunds
- Once we receive and inspect your returned item, we will notify you of the approval or rejection of your refund.
- Approved refunds will be processed within [7] business days and a credit will automatically be applied to your original method of payment.
Related products
- Edmonton Stock: 5
- Edmonton Stock: 5
- Edmonton Stock: 20
- Edmonton Stock: 34
3 w/ft Under Cabinet LED Strip - 254 lm/ft · 3000K · 24V · 16 ft
EV3-IN-16-24V-3000
89 – Loyalty Rewards- Edmonton Stock: 376
